Teradek Bolt User Manual download pdf (Page 2)

BEST PRACTICES

BOLT LEMO CONNECTOR / PIN−OUT

CUSTOM / 3RD PARTY CABLES

OPERATION

MOUNTING

Bolt uses a 0B 302 series LEMO connector (FGG.0B.302.CLADxx).

Pin Description

1* GND

2 +DC

* Pin 1 is closest to the red dot on the LEMO connector

• Check the power cable for shorts / proper grounding.

• DO NOT connect video when testing custom cables. Improper cable polarity and/or construction

may cause damage to Bolt if video is connected.

• For best results, allow 60 seconds after powering up the Transmitter and Receiver for them to select

the best frequency.

• For better signal quality over longer distances, maintain line−of−sight between the Transmitter

and Receiver.

• Mount the Bolt Transmitter vertically.

• Mount the Bolt Receiver vertically with the face oriented towards the Transmitter.

• Keep the antennas on the Bolt Transmitter and Receiver clear of obstructions.

• Velcro is not recommended for mounting either Transmitter or Receiver.

Bolt Transmitter mounted vertically on a camera

Bolt Receiver mounted vertically on a monitor

ALWAYS MOUNT BOLT TRANSMITTER VERTICALLYALWAYS MOUNT BOLT TRANSMITTER VERTICALLY

CAUTION:

Damage to the product caused by custom cables is not covered under warranty.

1 2

No comments

Teradek Bolt User Manual Page 2