Teradek Beam User Manual download pdf (Page 11)

2. Operating the Beam TX and RX

2.1 Front Panel Operation

Status Screens

Cycle through status screens or return from the menu by pressing the red Status joystick.

 Main Status screen – The main status screen displays the WiFi/Ethernet status, and encoder/decoder mode. On the Beam

TX, video input and encoder bitrate are also displayed. On Beam RX the decoder output and ID are displayed instead.

 WiFi – Displays the WiFi SSID and wireless IP address.

 Ethernet – Displays the current Ethernet IP address.

 System – Displays the device serial number and firmware version.

Menu Operation

Launch the menu and navigate through it with the black ‘Menu’ joystick.

Beam TX

Encoder – Contains controls for the encoding bitrate and frame rate

 Bitrate – Select bitrates between 5 and 30 mbps from this menu. Settings take effect immediately after they are applied.

 Frame rate – Select from Same as input, 25, 30, 50, or 60 frames per second.

WiFi – This menu allows you to configure the WiFi SSID and channel, or to enable Ethernet LAN mode.

 WiFi Channels/SSIDs – The Following options are available:

SSID

Wi-Fi Ch.

(Frequency)

SSID

Wi-Fi Ch.

(Frequency)

TeradekBeam_00

(5180 MHz)

TeradekBeam_07

157

(5785MHz)

TeradekBeam_01

(5220MHz)

TeradekBeam_08

(5180 MHz)

TeradekBeam_02

149

(5745MHz)

TeradekBeam_09

(5220MHz)

TeradekBeam_03

157

(5785MHz)

TeradekBeam_10

149

(5745MHz)

TeradekBeam_04

(5180 MHz)

TeradekBeam_11

157

(5785MHz)

TeradekBeam_05

(5220MHz)

Ethernet LAN

N/A

TeradekBeam_06

149

(5745MHz)

 Ethernet LAN mode – Select Ethernet LAN when using MPEG-TS or multicast over a wired network.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Comments to this Manuals

No comments

Teradek Beam User Manual Page 11

Comments to this Manuals

Related products and manuals for Accessories for video Teradek Beam