BEST PRACTICES
BOLT LEMO CONNECTOR / PIN−OUT
CUSTOM / 3RD PARTY CABLES
DEVICE OPERATION
BOLT MANAGER SOFTWARE
MOUNTING
Bolt uses a 0B 302 series LEMO connector (FGG.0B.302.CLADxx).
Pin Description
1* GND
2 +DC
* Pin 1 is closest to the red dot on the LEMO connector
• Test the power cable polarity with ONLY the power cable connected to Bolt. Do not connect video cables.
• Check the power cable for shorts and proper grounding.
Bolt Pro 600/2000
• Keep the transmitter and receiver at close range for 60 seconds after powering on the devices. This allows
them to scan for and select the best wireless channel.
• For best results when using multiple Bolt systems in the same area, place the transmitters and receivers
a few feet apart from each other.
• Operation of other wireless equipment may interfere with the Bolt for best results, separate other
wireless transmitters and receivers as much as possible.
Bolt Pro 2000
• If the receiver loses signal due to interference or it exceeds the maximum range, do not power down either
device. If the devices remain powered they will reconnect more quickly.
• While operating in Unicast Mode, if either device loses power, regardless of whether or not the link was
established, both must be power cycled before the link can be restored.
• Mount the Bolt Pro 600/2000 transmitter vertically, keeping the antennas clear of any obstructions.
• Orient the transmitter and receiver antennas so they are parallel to each other.
• For best results, orient the receiver antennas so each one has clear line−of−sight to the receiver.
CAUTION:
Using a reverse polarity or improperly−constructed power cable can damage the product
and is not covered under warranty.
Bolt transmitter mounted
vertically on a camera
Bolt receiver can be
mounted vertically on
a light stand or monitor
Bolt Manager allows you to configure and upgrade your Bolt Pro 600/2000. It is availible at
www.teradek.com/pages/downloads. The following configuration is available:
• Region Selection - Configure Bolt Pro to comply with your region’s regulations governing use of the 5GHz
spectrum.
• Frequency Selection (Bolt Pro 600/2000 only) - Use this to select which channels Bolt Pro will use during
operation. This must be set on both the transmitter and receiver.
• Transmission Mode (Bolt Pro 2000 only) - Selects between the following modes. Please see Bolt manager
for more details :
o
Unicast Mode (Default) - 1:1 communication only, but more frequencies are available for use.
o
Broadcast Mode - Up to 4 receivers per transmitter, reconnection takes less time.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals